BAMF2 RR (Receiver Ready)


All servos installed (KSTX08N v5.0)

All control and springs fitted

Rudder and Elevator pull cabes installed and pre-set for servo centre position

Aileron push rods installed

Throwing Blade installed

All you need to do is add your receiver and battery.


From the experience flying the BAMF for the past several years and taking a look at the events on the world stage... it seems that higher heights and higher penetration are always required to keep pushing forward. It seems that competition is biasing towards planes that penetrate very strongly with less disturbance from turbulence.Aerodynamically, the wing shape was modified to be less affected by turbulence while the lift is slightly increased closer to the root. All cross-sections on the fuselage are decreased and the pushrod exits are further refined for a tighter install. In terms of flying philosophy, we feel there are two ways to tackle high winds: fly extremely fast with a lower L/D so you can reach somewhere faster, so even though L/D is lower you will reach the target area quicker and less affected by the outside forces (wind & turbulence), or secondly slightly slower than extreme but retain very high L/D so even though it may take you a few seconds to get back you should get back with a little extra height.Personally I am not an extremely aggressive pilot with 40 hours of stick time per week, so I have always preferred the second method of tackling wind. As such, the Vibe was designed that way and if you've flown it, you will know it's not the fastest out there but comes back home with height to spare. Think of the BAMF 2 as taking what the Vibe had but further increasing the L/D and with a very strong launch height ability.Mechanically, I have always wanted/needed a model that can really break down small. As such, the BAMF 2 comes with a center split 2-piece wing with a fat carbon joiner, with the option of a very simple removable fin that will be strong enough for *most* pilots. For extremely powerful launchers, it's probably still safer to glue the fin on. The nose is extended to reduce the need for nose weight and to make gear selection, install and maintenance extremely easy.Of course, the BAMF 2 will continue to be made in Ukraine where we have had an incredible few years of production success. All models are made with solid Rohacell cores, carbon shear webs, and high-quality finish.Images shown are a representation of the model only and may differ slightly due to the handmade nature of the model. Structure: Solid Rohacell moulded wing and tails Light: CW30 skin Standard: CW40 skin Strong: Co-axial CW60 skin Tails: Carboweave skin 1-piece fuselage 2-piece wing (center-split) QuikLinkFlight Characteristics: Incredibly high launching Cuts through wind and turbulence at low weightSpecifications: Wingspan: 1495 mm Wing area: 18.55 dm^2 Wing airfoil: modified Synergy 2Recommended Gear: Receiver: FrSky X4R, G-RX6, Spektrum AR410 Servos: 4* KST X08N v5 Battery: 1S LiPo 380-520 mAh

RR (Receiver Ready) BAMF2